942 and Dish 1000 install question

[cruiserman]

I am upgrading my Dish Network system. I am going to get a 942 in the bedroom hooked to an HDTV with a standard TV in the kitchen hooked to the other output on the 942. I have another TV in the living room (standard for now but will be upgrading to HDTV) that I had a splitter on that went to a fourth TV in my office.

How should I wire in my Dish 1000 to provide signals to the four TV's without more than 2 receivers. I do not care if the one in the living room and office have to be on the same channel or not. The Dish 1000 has the dual lnb along with the DP Plus Twin. I would like the option of receiving the Voom channels on the HDTVs though I am not sure that I will get Voom until they get the movie channels.

Diagrams would be great, but I cannot find anywhere that deals with a setup like this.

Thanks!

[Admin]

Your setup is simple and straight forward.

The DISH 1000 twin LNBF has two outputs. Connect one output to your your 942 receiver using a DPP separator by the receiver side.

Use the 2nd output on the twin LNBF to connect the receiver in the LR. In the living room you can use a DISH322 receiver with two tuners. If you do, you will need to use a DPP separator by the receiver side as well.

:mozilla_laughing: