Fullfilled

FULLFILLED · #1 (**permalink**) 04-28-2007, 02:37 PM

I purchased a HD20 receiver. The new AU9 dish for direct TV . A new Sathawk 4000 to tune in. How the heck do you line up the dish to receive 101, 110 and 119. I can get any one at once, but not all three at once. Being an amateur in the Bahamas one of you smart guys can help me out.
Thanks

Corey · #2 (**permalink**) 04-28-2007, 03:36 PM

I have not installed an AU9 before, but if it's anything like a Dish 1000 which has 3 LNB's, you just need to read the directions on the installation guide for the dish. For Dish 1000, they told me to point the dish at one satellite (119) and peak the signal for that one. If you have set the skew correctly, the other two satellites will be picked up by the other two LNBs once the receiver sends the signal to switch LNBs and tune into the other satellites.

FULLFILLED · #3 (**permalink**) 04-28-2007, 04:01 PM

Thanks Cory. I think the tilt is the one that may be off. Still learning out in the hot sun. I will get it sooner or later.