I recently installed a
Twinhan card and this is how I have been able to tune in T5 on Ku. I have a C/Ku band dish and have splitters attached to the C/Ku band cables going to my GI450i. The GI450i passes the LNB voltages and control the dish position AND Vertical or Horizontal control of the LNBs.
I am currently connecting the C/Ku cables manually. Heres how I just set it up again.
Ku cable from spltter to LNB in of PCI card. Run WinDVB. LNB & switch settings as follows: Setup 2 Type custom frequency 1 and 2 10750. Everything else disabled. Power off, DiSEqc disabled.
Dish setup: Dish 1, fixed, T5, LNB2, polarization Vertical. (You need to set your
C-band receiver to T5 and channel 22 which should be vertical or any other vertical transponder.) Hit scan one satellite and the Twinhan should scan in some channels. I just did this again and had to save another file. I am currently watching the X-files in english on MBC!
To scan in the Horizontal channels you have to set you transponder to horizontal with your c-band receiver. I am sort of figuring out things by trial and error. Speaking of errors, the "failed to set program" error can be caused by many things including dish not on correct sat., LNB not set up correctly, or channel is encrypted.
There are many signals on T5 so try this sat. first. BTW sig. strength 47%/sig. qual. 49% and still a good picture.
Hope this helps, I am new to FTA, too.
Linear Mode
