HELP

[Jackfish]

Hi all

Ok frist here is what i am working with
p4 2.4
xp sp2
786rm
ait 7500 64mb
VisionPlus 1020A

ok get lots of strength with 0 quality
have tried the walk thoughts was useing . ProgDVB

man any help would be great
Thanks

[wejones]

Hi all

Ok frist here is what i am working with
p4 2.4
xp sp2
786rm
ait 7500 64mb
VisionPlus 1020A

ok get lots of strength with 0 quality
have tried the walk thoughts was useing . ProgDVB

man any help would be great
Thanks

Your "here is what i am working with" doesn't include a dish or lnbf.
You should also indicate what you are trying to receive, as it may not be possible with the combination of dish/lnb you have.
First, the "strength" doesn't always mean you are seeing a sat signal, because often the background noise registers as a strong signal.
There are many reasons for not getting lock/quality. Usually it is
1. dish isn't aimed right or dish too small for desired satellite
2. wrong lnbf type entered for lnbf
3. wrong LO freq entered for lnbf.
4. wrong transponder data entered, ie freq/SR.
5. wrong polarity if a slaved receiver
6. wrong lnb selected by switch if a slaved receiver
7. no power on to power diseq switch if a slaved receiver.
etc, etc .
Need to know more about setup.

[Jackfish]

Hi all

Ok frist here is what i am working with
p4 2.4
xp sp2
786rm
ait 7500 64mb
VisionPlus 1020A

ok get lots of strength with 0 quality
have tried the walk thoughts was useing . ProgDVB

man any help would be great
Thanks

30 in dish
Galaxy 11
have two lnb using one at a time
1 dss lnb
2 StarChoice round type lnb
no switch
have Sat finder so dirction is good

[wejones]

30 in dish
Galaxy 11
have two lnb using one at a time
1 dss lnb
2 StarChoice round type lnb
no switch
have Sat finder so dirction is good

Satfinder can tell you if you are aimed at a sat, but won't tell you which one, and if on the wrong sat, the transponder data will be wrong, and you won't lock on the channels you are looking for. Ie , how do you know you are looking at G11?
What channel are you trying to lock on G11? Most of the Ku signals on that sat are feeds that aren't full time, ie might not be there when you look, except for what Lyngsat calls a test card on 12060 (I haven't tuned this myself, so I'm taking Lyngsat's word for it. )
The DSS lnb won't work on G11. The other one should, assuming it is a linear , although I'm not familiar with that one. I'm also not familiar with ProgDVB, but make sure you are using 10750 as the LO freq with the StarChoice LNB (again assuming here), and make sure you have entered transponder data for channels that you know are active (ie the 12060 above).
I noticed a thread by you in another forum, that indicated that you were trying to tune in Nimiq and G11, perhaps at the same time, which won't work.

[Jackfish]

had it working with the dss lnb

lof1 -0
sw-0
lof2-11250


getting Q70 to 90
S60 to 90


then lost ever thing no TP showing up when i scan for them lol
not sure now