No signal on MT but some in VisionPlus. WHY?

[freetv]

I am using TH1020A PCI card, a SatContron SM3D12 motor, 36" dish, and my dish is pointing at Echostar 7. In VisionPlus I got 70 on signal strength and 39 on Signal quality on transponder 2 and 5. I went to MT and scan on Echostar 7 with both freq. at 11250000. I get NO SIGNAL on all transponder.

WHY?
What did I missed?

Please help.
I am in South California, if this helps.

[Plusmicro]

Which satellite is Echostar 7? Thanks, even if your pointed at nothing Mytheatre will report a signal strength. I would suggest using a signal meter to line up properly.

[ae]

make sure that both lof 1 and 2have 11250000. Just worked for me. I was having the same problem

[freetv]

Thanks ae.

I figured that out, thanks. My 36" dish has an lnbf and my oval dish has 2 lnb. The setting for lnbf and lnb are different. I adjust that and got some transponder to response.

Thanks for all suggestion.

Plusmicro,

Echostar 7 is my closest true south satellite. It's at 119 degree (around DTV's sat).

[anthonyb93]

I am having the same problem in not getting a signal in MyTheatre. I have a triple lnb dish and am attempting to get the echostar 7. I know the signal is there because i am using the same dish in a dish network receiver and it reads fine. Any help would be greatly appreciated. Have changed my LO frequencies and still get nothing in MT.

[Isaac]

Put lof1 0
sw 0
lof2 11250000

[SONOBOY777]

I have been using MT and Vision plus for a while now. Had to reallign my dish (with sat finder and compass). Now I can load chanels (300 of them on echostar sats alone) visionplus software says 73%/36% but MT says 0%/0% ?? This has never happened before. Any pro theories? 1 lnb all other time tested numbers are correct.