:cry: Actually, nothing seems to be working. I had to disconnect the
DiSEqC switch in that it refused to switch (stays on LNB-A). I'm using a universal LNB with the dish pointed at T5. If I feed this siganl into my IT912S, it works perfectly. Feed it into the 1020a and I can't get a lock on any channel. I can manually change the polarity, but the output voltage to the LNB remains at 13V. Unfortunately I only have the one 1020a and one DiSEqC so I can't switch them out. All I know for sure is when I connect to a known good signal source, the 1020a refuses to work. Yes, I've checked the LO frequency, DiSEqC setup, tried both the preloaded list for T5 and tried entering transponders manually... both fail. :cry: :cry:
Linear Mode
