problem with T5

[mr_roger]

I have Fortec Ultra /Motor, 121/119/110/91/82/61.5 all at 90%,
but I have only 2 transponders on the T5 (11836 & 12177) @ 60% and all the rest are 0%, I'm trying to find 12146 but it looks impossible, please help.
:?: :?: :?: :?: :?:

[vj9999]

What size dish and what type of lnbf do you have?

[mr_roger]

What size dish and what type of lnbf do you have?

I have alpha star 35" and I had a KU lnb (Radar) I changed it to Invacom 0.3 db LO 9.75/10.6 GHZ
:?:

[pictureon]

The lnb that you're using now is universal so make sure that T5 antenna lnb is set to universal. All other satellite that you're getting have very strong signal so I suggest that you adjust your motor on T5 then the rest will be just fine. Try this>>> Menu>Antenna setup>select I5A (T5) hit OK
go down to frequency and change it to the one you need. On the line below (Positioner setting) Change that to 1.2>Hit OK go down to nudge east/west and move the dish with the left arrow on the remote and see if you get better signal. If not then move the dish with the right arrow. If you get better signal go down to store and that will store your current setting. If you do not get better signal then the problem could be with the elevation and then you need to go out to the dish and try to adjust that. also make sure you do not have a cable that is too long, bad switch or bad lnb. Good Luck...

Note: if you do not want to save setting just hit exit and everything will go back to original settings