[Admin]

on your Longitude value, you could switch to 92.6 W. To change the E to W use the Page Up button on your remote.

Also, you don't need the 12V ON unless you have a 0/12V switch connected to your receiver.

Change the positioner settings to DiSEqC 1.2. In that menu, select 0 Reference. This will "recalibrate" the motor. The motor will move all the way EAST (that is normal in this motor) then go back to 0 position. Change back to DiSEqC 1.3 and check again.

After the above, if all fails, try to do a MASTER RESET on your receiver and search the satellites again.

Good luck and happy surfing.