My
SG2100 works fine, the only thing I don't like is that it's not fully USALS compatible, so I end up using it in Diseqc 1.2 mode. I use Fortec 786v3 with this mount.
Michael
Quote:
|
Originally Posted by Skelp
Ahh, ok thanks Michael. Based on what it says on the back of it horn A is 0KHz and horn B is 22KHz. I figured if I use an SW-22 switch with the two LNBs and set the cirular one to ON and the linear to off if would just use horn A on the StarChoice one.
I have also rigged up a mounting bracket that will allow me to make sure both the circular and linear LNBs are as close to center as possible.
I'm hoping it works....
Also, I've just started running into problems with the motor.. when I hit Go to reference it won't go to 0. It goes to 15 for some reason. Tried a hardware reset and everything and it still does it.... On another SG2100 motor I have here for some reason it won't move the dish when I change to a channel from one bird to another. It's set on 1.2 for positioner setting.... do these SG2100 motors have a history of not acting properly?
|