Cody
Your dish elevation angle is correct at 23.6 and that's what you should adjust your dish at using the scale on the back of the dish.
Your
HH100 angle is wrong. You should change it to your Latitude value (41.7)
Make sure the motor, dish, feedarm, and LNBF are all pointing at true south (about 165*).
When you select a satellite, make sure you also select a "LIVE" transponder from the TP Data. To check what is live on that satellite check the Lyngsat.com charts.
Enter your Lat/Long into your receiver. Make sure your Longitude value is followed by blank and not "E". To change it from E to West, use the "PAGE UP" button on your remote.
Click OK on USALS
The Motor will move to your satellite. If your dish
installation is perfect, you should see a green signal and quality when the motor stops. If not, try adjusting your motor azimuth slightly East or West until your get a green signal. Maximize your quality. Adjust your dish elevation slightlu to peak/maximize your quality.
Once quality/signal are maximized, click on "START" to start searching the channels on that satellite.