Slaving your Fortec Star 786v3 receiver to your BUD C/K dish.
We get a lot questions about that. You will need to setup your receiver to accept your installed LNBs on your big dish.
You will need splitters and 2 Way
DiSEqC switch to do the connections per previous post.
Connect you
C-band LNBF to Side 1 (A) of your DiSEqC switch
Connect you KU-band LNBF to Side 2 (B) of your DiSEqC switch
In the receiver's Antenna Settings Menu:
Set Antenna 1 for C-Band
LNB Type: SINGLE (Click OK on Single and change LO frequency to 5150)
LNB Power: V/H
22Khz Tone: OFF
DiSEqC: 1
12V: OFF
STORE
Set Antenna 2 for KU-Band
LNB Type: SINGLE (Click OK on Single and change LO frequency to 10750)
LNB Power: V/H
22Khz Tone: OFF
DiSEqC: 2
12V: OFF
STORE
In Channel Search, select the satellite you want to search channels on.
Select Antenna 1 to search the C band signals
Go to Start
Repeat again for the other polarity
Repeat again using Antenna 2 for KU band signal.