Quote:
Originally Posted by Larry Acklin
If the dish feed is old- cband version that uses a servo (blue box on the back with 3 wires) then the best way is to completely replace the feed.
The channels (odd/even) are controlled by that servo, and you will have to change channels manually on the old receiver to get both horiz and vert. transponders.
Which is a hassle.
The bsc621 is well regarded in this forum.
I have recently replaced the positioner system on my BUD with a vbox and I am on the verge of replacing the feed with the BSC621.
Larry |
Thanks Larry,
I don't know if mine has a servo. It had a Ribbon cable (with three leads) going through the feed, however only one lead was connected. I will double check it to see if the other two cables were missing connections.
In the case that just one cable is needed, then I would not worry about the polarity, isn't right?
__________________
ZIP Code 36830
Fortec 80cm dish, ULN1 0.4dB LNBF
Fortec Star Mercury II, PowerTech DG240.
Last edited by mbaltazar : 04-14-2008 at 01:37 PM.
|