Run a check on your LNB to see if is drifting, if it is, need's to be replace. Also check the level on the mass where the dish is attach to see if is level, the level has to be front and side, if is not level that will give you problems too.
Quote:
Originally Posted by Here2Learn
I took the receiver outside
along with my tv and had an RG6 from Port 1 hooked directly to Receiver. I am getting over 80% signal from 119 & 110. I then switched the RG6 to Port 2 to ensure it would work and it worked fine.
The problem is when I hook up the 2 nd receiver in the house I don't even get a signal when I point dish. (kind of useless to run check switch but I did anyways and all I'm getting are 4 XXXX's. Port 1 works fine ...I am running an RG6 directly from port 1 and port 2 to each individual receiver (508's, yes they both work) like it says in all the instructions. It has to be something simple but I certainly can't figure it out. Any suggestions would be appreciated!
It's like there is no power from the lnb...just my 2 cents...
|