Have spent two weeks trying to install a Fortec 31" Dish onto
Moteck SG-2100 motorized system with either ULN-1 or IVACOM nf .03 Db LNBFs. Have tested Coolsat HD8100 and Viewsat 9000HD receivers. I'm certain the dish was pointed towards true South to start. Dish elevation computed and set to 28.5 degrees. Used USALS to set the motor at 117.5 degrees W longitude and 33.9 degrees E latitude. Used small TV and receiver out of doors at dish site for setup. Connected LNB and receiver(s) to motor. A "static" 65% signal strength appeared in the satellite setup area. The quality signal remained at 0%. The signals remained at this level no matter which direction (EAST/West) I commanded the dish motor to move. There was no change in the 65% signal or 0% quality readings even when large or small adjustments to the elevation were made. I'm wondering, since there's a fully operational DN motorized system working here, that maybe the above mentioned components are not compatible with my receivers. Appreciate any feed back.