Quote:
Originally Posted by rainman
make sure you are using a active Transponder freq and that the lnbf LO is set correctly for the type of lnbf you are using. see LyngSat - Lyngemark Satellite for active Transponders.  |
lnbf LO setting - I assume you mean on the receiver. Well there is none. I checked all the coolsat 6000 options, install screens. Nothing about the LO setting. The freq of lnbf LO is 10.750 per the sticker on the lnbf.
So far, no signals in any direction at any elevation...nothing. When I put the freq of the sat to 12.740 I get no reading on the signal meter at all....0. On other frequencies the signal reading is no lower than 88 and no higher than 91%....still red. And Quality is stuck at 3-5%. Nothing. Any other ideas? Why am I not getting any signal from any satelitte. I'm moving this thing to hell and back, doesn't the law of averages say that I should stumble on some signal somewhere? I am pointing to the same general area I did with the 18in dish and had signals from 110 and 119. At this point, I don't know what to do. Forget the motorized part. I cannot move this 90cm dish to get any signal manually either. Any help is appeciated from this forum.
Thanks,
Losbanos99