[rainman]

Originally Posted by stevems70

Thanks. I can now move the dish to a specified sat angel however I cannot get the quality signal bar to registure anything. The Level meter reads at 78%. This Pansat receiver has a Diseqc setting of choice #1,#2,#3 and#4. I dont know which one to select. This is other than the Diseqc 1.2 with USALS setting. I can get the dish to move in the USALS window when i hit move. It will not move in the Diseqc 1.2 mode.??

the #1 through 4 is for a diseqc switch if you are using one. in other
words you are using more than 1 lnb you would need a diseqc switch to select each lnb if you are only use 1 lnb then you won't have to worry about this setting. you will need to start at your true south sat ( closest to your longitude) to align your dish. set the motor to 0 then move the motor and dish to point to your true south on a compass then use USALS to move to your true south sat then adjust the mount east and west to you get quality lock then fine tune the elevation to get the best quality then you should be ready to try for another sat. remember to use a active transponder freq and sr freq when searching.