[wejones]

Are you talking about a factory reset of the motor, or of your receiver?
What do you mean that you are "using Usals with Disceq 1.2" , these are different with respect to whether the sat positions are stored in the motor or not.
If you did the factory reset on the MOTOR, then, the motor should have been positioned at it's zero position when you did the reset, otherwise, I think all the positions will be off after the reset.
If the reset was of your receiver, and you are using DiseqC-1.2 instead of USALS, then you have to make sure that you use the same DiseqC-1.2 sat numbers, or else the receiver will be sending the dish to the wrong sats.
If the reset was of the receiver, but you're using USALS, then I don't know what the problem would be, assuming that you are correct, and you have disabled the limits.