2 receivers can not controll the Diseqc 2 ways at the same time. Remove everything immediately, connecting both receiver to a 2 ways spliter might damage both receivers/lnbfs for good.
Now you have 2 choices.
1. Upgrade lnbf to duals for both dishes. Then use 2 Diseqc 2 ways, each Diseqc is used for each receiver. Setting up this way, both receivers operate independently, but you have to run 2 cables to your house.
2. Slave one receiver to another. Connect the signal input of 2nd receiver to the signal output of the 1 one. Let the first receiver control the dish and polarity. Remember to turn off the lnb power for the 2nd receiver. Setting up this way, both receiver can only watch channels on polarity, same satellite.
Michael
Quote:
|
Originally Posted by lcmsd
Hi,
I have Two LNBFs hooked up to a 2x1 DiSEqC switch. Then one coxal RG6 cable into the house, inside the house I want to split the signal into two rooms, I used a High frequqnce 2 way all port power passive splitter.
However, I found that it was not working as I thought. When I connect bothe the two receiver to the splitter, only one of them can work. The other one either can not get the signal or get verl bad signal. :roll: :?:
What should I do? |