Need help with actuator!

[BrianC]

I can't get my new actuator to fit squarely from the mount to the dish.
It's a superjack II and I have a 10' Channel Master dish.
It is strange but the dish hole is much lower then where the mount hole is, thus too much of an angle (beyond the pivot points of both sides).
I'm thinking there must be either a kit or fix for this.
I thought maybe a longer bolt on the mount side?

Any thoughts or ideas?

Thanks

Brian

[tdti1]

Hmm not sure on that one, but would recomend you go to the big dish forum:
www.4dtvrocks.com