no siq on c or ku

[Vitruvius]

Look at the alignment of both LNBs when installed and try to figure out where the working Ku is aligned to on your dish. I suspect your C-band LNB should point to the same location. It looks like you have two different mounts for the LNBs that may have different angles, is that correct? Then, you may have to adjust the lnb for focal distance by pushing the thing closer or further away from the dish.

[LINC1]

yes that is correct the angles are different. so i went and purhased a new dish with a straight arm (1.2m)dish and the two lnbs do now go to the same point on the dish. The QPH031 gets a good S and Q but with the ku/c i dont get any thing regardless of where i move it weather it be in or out or putting it to 0 because it is motorized so i am at a lose on this on. Is it possible that its a bad lnb ???

P.S. I have been installing dishes for about 3 years this is the only one that doesnt work as it should Or is it just me which is possible.

[elgemcdlf]

I would not worry about the C Band at this point. Concentrate on getting Ku. 120 is awful small for C Band. I know some are using them but it is still small. You state skew is at 0. This is with the dish at center of the arc correct? What are your settings for the lnbf in the receiver? Is it a standard or universal? Once you get Ku if there is C Band available you should have it providing your settings are correct. If your new lnbf is a universal and you are still using the standard settings from the old lnbf that could be the culprit.

When I was aligning one of mine I put a flashlight in the lnbf holder which showed me where it was pointed on the dish.

[LINC1]

ok i did use a laser light to see where thr QHP031 was pointing at on the dish and the c/ku lnbf is also pointed in the same place but no ku at all but the c-Band does work. i have 90 to 100% Q on the old lnbf but nothing on the c/ku lnbf so what is the problem i think its the linear on the new lnbf what do you think? i have tryed the univ and the standard settings etc,etc but not a thing for Q and the S seems to never change when on linear