Problem w/HH90 Motor

[Ski5010]

Yes i have had this motor for about 1 yr and all of a sudden it stop turning for me,Do i need a new motor or can i fix this one without to much problems,and if so is there a diagram of the inside to it on the website somewhere so i may learn how to repair it.Thank you

[rainman]

Originally Posted by Ski5010

Yes i have had this motor for about 1 yr and all of a sudden it stop turning for me,Do i need a new motor or can i fix this one without to much problems,and if so is there a diagram of the inside to it on the website somewhere so i may learn how to repair it.Thank you

I would check all the coax connections to it first and connectors make sure they are clean and snug. if it turns out to be a motor you probably replace it cheaper than fix it.

[Ski5010]

I took motor off dish brought inside and hooked it direct close to receiver and still nothing.Boy it didn't last very long did it.Till me what other motor can i use in your store.I have a 31in dish i also a Pansat 3500 receiver .Thank you

[Sadoun]

The STAB brand has been good and no problems. Since your STAB motor is less than 3 years old, it should be still covered under warranty. If you still have the receipt and you did not open the motor, you can send it to Fortec/STAB repair depot.

Email Fortec/STAB repair depot for RMA #.

A good quality motor we have is the Digipower DG280. This is a strong motor (much stronger than the HH90) and is very accurate.

[Ski5010]

Thank you for your fast response,WOW!!!! The only receit i would have is from paypal ,will that work or not.Thank you

[pmb1010]

I sent my defective HH90 to Fortec Canada (stab North America distributor) and they repaired/replaced it. No problems, they were very courteous and efficient.

I posted about it on this forum someplace, if you search it might still be here. Had some contact info for them in the post(s).

[Ski5010]

I tried to search your post but it only wold put up 1 page for some reason,It shows 1 of 500 Thank you.