Hi all,
maybe someone can help me with this problem.
I have CW600SP /
Invacom 31 /
SG2100 / Fortec 33"
I have two cables going from Invacom L and C output to switch. Linear is connected to LNB1 and Circular is connected to LBN4. From switch output cable is going to motor and from motor to receiver.
I spent some time adjusting motor and now I'm able to receive 6 satellites with strong signal. My problem is that I'm only receiving circular transpoders. I can't find any linear transponder. I tried with default transponders and nothing. I deleted all default transpoders and enter new from Lyngsat but still nothing.
Just for reference this is my setup for AMC 5 which is true south from my location and I should use it to align motor/dish:
Transponder: 11742 v 22220 3/4
LNB Freq: 10750
LNB Type: Normal
22KHz: Off
Diseqc Number: LNB1
Legacy SW: Off
Motorised system: Diseqc 1.2
I'm scanning left and right and quality is 0% on all linear transponders on all satellites. I'm really confused, I'm receiving circular without problem but I can't find any linear.
During setup I connected linear output from Invacom directly to Satellite finder and then to receiver. I was able to receive strong signal on Satellite fined so I assume that Invacom is working fine but still there was no signal on receiver. Am I missing something is receiver setup?
Please help because I have a fealing that I bought faulty receiver...
Thanks!