This is what I was told to do off one of the FTA forums. I have 3 Zinwell 6x8 which (I have included pictures off) that I want to use instead of the 4x4. We are still confused about the two flex port ports on the Zinwells. What are they for?
[FONT='Verdana','sans-serif']I still think going 110% Legacy would be a lot easier for you[/font][FONT='Verdana','sans-serif']
You would need:
(3) 4x4 multiswitches
(3) DiseqC switches
(4) Legacy Duals
two cables from each dual lnbf goes to one side of a
multiswitch, like this:
119w to the ON side of 4x4 #1
110w to the OFF side of 4x4 #1
91w to the ON side of 4x4 #2
82w to the OFF side of 4x4 #2
61.5w to the ON side of 4x4 #3
97w to the OFF side of 4x4 #3
One cable from 4x4 #1 goes to port 1
One cable from 4x4 #2 goes to port 2
One cable from 4x4 #3 goes to port 3
Settings:
119w
LNB Type: Standard, LNB Freq: 11250, 22khz: ON, DiseqC: 1, Legacy SW: None
110w
LNB Type: Standard, LNB Freq: 11250, 22khz: OFF, DiseqC: 1, Legacy SW: None
91w
LNB Type: Standard, LNB Freq: 11250, 22khz: ON, DiseqC: 2, Legacy SW: None
82w
LNB Type: Standard, LNB Freq: 11250, 22khz: OFF, DiseqC: 2, Legacy SW: None
61.5w
LNB Type: Standard, LNB Freq: 11250, 22khz: ON, DiseqC: 3, Legacy SW: None
97w
LNB Type: Standard, LNB Freq: 11250, 22khz: OFF, DiseqC: 3, Legacy SW: None[/font]