Quote:
Originally Posted by Greysquirrel
Have a SG 2100 and did a hard reset at the motor by moving the motor to 0 or as close as it would go, shutting down the power, by either disconnecting the F connector to the motor or shutting off the receiver, I chose to take my receiver outside and using it, then holding in the E & W buttons, reconnecting the power and when the led had blinked 15 times and stopped I released the buttons and the motor went to zero and I have no more problems. On the older motors with one button you get a paper clip and there is a small hole by the button that you put the paper clip into and it will reset, a much easier way I think to do it but they made it easier to jog the motor by using two buttons instead of one.
|
Thanks. Good info. I have the version that uses a paper clip, but I haven't tried that yet, since I'm OK using DiseqC1.2
Thanks.