Quote:
Originally Posted by wejones
Good info. What motor do you have. And I assume you're talking about a hard reset where you move the dish to it's real zero, then push the reset button on the motor, or something like that? Or was it a reset done with software from the receiver?
Either way, good info. I figured that this would work but wasn't positive, and since I had already programmed in all the sats with DiseqC1.2, I didn't want to mess things up, so I never bothered to try.
|
Have a SG 2100 and did a hard reset at the motor by moving the motor to 0 or as close as it would go, shutting down the power, by either disconnecting the F connector to the motor or shutting off the receiver, I chose to take my receiver outside and using it, then holding in the E & W buttons, reconnecting the power and when the led had blinked 15 times and stopped I released the buttons and the motor went to zero and I have no more problems. On the older motors with one button you get a paper clip and there is a small hole by the button that you put the paper clip into and it will reset, a much easier way I think to do it but they made it easier to jog the motor by using two buttons instead of one.