[overthehill]

Help! This all seemed straight forward at first.
How exactly should the motor be wired. From the receiver, this is how I have set up: single RG6 to ground block, single RG6 between ground block and 4X switch, LNB #1 RG6 w/messenger to motor, then LNB, LNB#2 RG6 to LNB. All are gounded properly.
Intial test moved dish about 8-10 degrees, then stopped. Now I have blinking orange light and nothing else.
I would have preferred to hook the ground block before the 4X switch.
Do I have the 4X switch wired proper?
How are the tone bursts A + B used? I haven't touched them yet.
Where do I go from here?