When I blind scan, it comes up blank!!!
I had my MercuryII hooked up with the 920. I wasn't getting all the channels that I should have so I disconnected the disq switch and hooked up just the c side from the non dc pass splitter to the MercuryII (left the dc pass to the 920) this took out the switch and the ku band. I was on a satmex 6 and had some channels. After I took out the switch, the MercuryII had no signal. So I tried a few more sats with the 920 then check the MercuryII still no signal. So I put on a used
c-band norsat lnb that I just got two days beforehand thinking something must be wrong with mine.
I hook it up and tried again, same thing.
So I took the 920 to G1 5 and had channel, I then disconected the c-band cable off the 920 and the channel was gone -normal. I put cable back and channel return. I took ku cable off and channel was still there -normal. So I tried some more with the MercuryII no luck. I hook the switch back up and had signal again on the MercuryII and had the prescanned channels, but every new blind scan even on the same bird with channels comes up blank.. no freqs no channels..
I then took off the big dish stuff and went back to normal fta with the fortec dish I got from Sadon.
I went to a sat that had channels that I prescanned, all channels still there and working. I then deleted the channels from that sat and did blind scan. Scan came up blank. So I went to another sat that had channels and left the channels and did a blind scan, still comes up blank.
Take note I had tried channel backup, reset, channel recovery several times. Unplug the unit overnight. I even put on the new May firmware with all the before and after reset and still won't scan anything in. Just comes up blank. Everything is hooked up right..