Fuzzy,
1.For the motorized dish, any switch must be installed between the lnbf(s) and the motor.
2. 3x4 switch will not work propertly if you use Diseqc command to control it. Use the Diseqc 4x1 to switch the lnbfs. I am sure the Satwork support Diseqc 1.0/2.0/1.2.
Again, If you plan to make both receiver work indepently, you have to upgrade the both lnbfs to dual, then run 2 cable into your house, one of the Satwork, the other for the Bec. You can either use Bec or Satwork to move the dish.
Micheal
Quote:
|
Originally Posted by fuzzy
ok but the way i got it now is the satworks is the main reciever that moves the dish and i got the 3x4 switch between the motor and dish and thats what i hooked the bec reciever too like i said i can view everything on that one satellite on both recievers but if the satworks was to move the dish the bec reciever would not view anything and yep it worked. But i still can't seem to get the dtv lnb to work like i said before i set the lo freq. to 11250 and i tried that on unversial and normal but still nothing. hmmmmmmmmmmmmmmmmmmmm
mike |