|
I don't know much about the Diseqc commands, but you are correct, that is sort of a splitter. You can connect several LNB's to this and run a single RG6 cable to your receiver. Your receiver will allow you to send Diseqc commands to the switch in order to select which "port"/lnb you wish to view.
If you run a motor on your dish, you will need to connect the Diseqc AFTER the motor, as most of those switches will not pass the necessary information on to a motor (although there are a few switches that will, I doubt the freebe one you go will do that)
__________________
I like to shop at Sadoun Satellite Sales
Dishes: 2 Primestar 75E, 2 Fortec 90cm, 2 10ft, 7.5ft
Motors: 2 SG2100, SkyJack 24" & 36" actuators
Movers: 2 VBoxII
LNB(f)s: Invacom qph-031, Primestar, dual/single ku, BSC621,Geosat dual C-Band, 2 Polarotor, Corotor
DVB Receivers/cards: 2 Fortec Classic NA, 2 Dreambox 500-s, SatPros DSR-550s, Digiwave DG7000, Lava 3200, Pansat 2500a, Viewsat Ultra, Twinhan 102g
Analog: Zenith 1000, GI 2400
|