Got my vbox2 and the BSC321-2 C/Ku LNBF for the 8' ft dish.
Started out by by-passing the coax on the unit. I was able to extend the arm out from Horz. to my south sat which is 95. I went east to west several times before moving inside.
After inside I hooked back up but this time with the coax to the unit.
I did a blind scan and pick up chanls and verfied with lyngsat that it was correct bird.
I then decided to go ahead and store the location as location 30. On the ku side there was some chnnls not coming in to good so I hit the west button, watch the dish move, no improvment. after a few attempts, I then try going east with an Error Er2! no dish movement. I then went into setup and set the positioner to diseqc 1.2 (was set at none) still no luck. Reset the
vbox several times no luck. Change the moter leads from e to w and then with e being west stills goes west but not east.
Er2 Message (No Pulses)
Re-check the wire connection.
Make sure the
actuator is not stopped by Mechanical Limit.
Check if the Reed Switch Sensor is broken.
Check if the Motor is broken.
Any clues...
(never set the limits on the mercuryII nor the vbox and haven't mess with the outside
c-band limits.) Dish moved farther east and west then now and now everytime I go more west I lose that much more east.
thanks