[rainman]

ok lets start at the beginning.
1. set motor azimuth to 0 ( reference on some receivers)
2. set motor lattitude scale to 40.5 degrees
3. set dish elevation to 24 degrees
4.set up transponder to 11741 horiz sr to 6616
5. loose the birddog and use a tv and receiver at the dish
6. set the dish and motor on the pole to 192 degrees on the compass set the lnb to 0 at this point (cables pointing at the ground)
7. use usuals and move the dish to SBS6
8.mark the mount and pole so you know where you started
9.move the whole assembly on the pole east and west to find quality signal on the receiver if get know quality start back at beginning mark raise or lower the dish by 1 degree and try east to west again repeat untill you receive quality signal.(remember slow small movements allow 15 seconds between move for receiver to see the changes)
10 after you receive quality signal make minor up and down east and west adjustments to get best signal then check other sats to check quality fine tune as need.