[rainman]

the M2 system comes with a 80 cm dish did you up grade if so do you have the 100 or the 120 as sadoun don't sale a 110.

set your motor to zero on the azimuth scale then set the motor elevation to your latitude on the latitude scale set your dish elevation to 23.7 set your receiver lnb setting to universal lo freq to 9750 and hi 10600. install a active transponder then using usuals move the dish to G10r then adjust east and west with the mount on the pole to find signal slow small movements allow 15 seconds for receiver to see the change best with a tv and receiver at dish. if you get no quality raise or lower dish elevation by 1 degree and try east and west again repeat steps to you get a lock.it's also a good idea to mark your true south position on the pole so you can see how far you have moved 1/8 inch can make or loose a signal and it is best to try and get a lock on your true south sat first as it makes alignment to the other sats easier.the tree should not be a factor as off set dishes aim 22 degres higher than they are pointing. hope this helps and good luck. also the 22khz switch should be set to auto.