Quote:
|
Originally Posted by wejones
You might be able to make an indicator of some kind. To calibrate it, I think the key is that the reading on one side should = 90 minus the reading on the other side. If I remember right, that washer had some kind of prongs or something that kept it square in the slot.
However, it's probably easier to just use an inclinometer on the motor, and ignore the scale.
|
I could use an inclometer, great idea and I will so that for sure.
I do have to admit I disassembled the bracket and found an a pointer on both sides built into the casing as mentioned by Elgemdcff in the above post.
I didn't see it or recognize it as a pointing device for a while.
thanks to all for your help.
orogle