Having problems with my setup.
Viewsat 2000 plat.
STAB HH90 motor
Invacom LNB ( circular and linear pol.) quad
DISEq 4+1 switch between LNB and motor
Receiver will not move the rotor/dish between two satellites.
Receiver will send the dish/motor to one location>> bird is found.
When moving from one bird to another>>> mostly it is unseccessful>>meaning>> rotor moves, but does not calculate properly the location!!!
The receiver has to be turned OFF then back ON>> the rotor only then moves to TRUE SOUTH ( or close to it) and then moves to the desired position of the new bird.
Any ideas how to solve this problem??
Thank you all on this forum.
Latitude and longitude, motor elevation angle are O.K.
Switch has ben changed, just to eliminate some possible problem.
Line (RG6) are only few meters long.
Receiver has been reset to factory setting at least 3 times.
Using USALS. No other option except USER,
INSTALLER, USALS on the receiver's menu.