Hello, I too just purchased a 3x4 switch which i currently hooked up to my reciever and am only getting some sats and not others, I only have one rg-6 cable going into the 18v side must both the 13 and 18v ports have cables going into them, if so that means that I have to run two diseq switches and then the cable to each port on the switch, Iwant to have 4 tvs ready to go, for this I will be moving the viewsat receiver as I go. My setup is a viewsat vs 2000
platinum an
invacom quad lnbf a
sg2100 motor and a gemstar dish any help would be appreciated.