Quote:
|
Originally Posted by ftagreenbean
Sorry for the late response... I didn't get a chance to try it again until this morning. Still not working.
For the elevation, where should the angle be measured?
- the vertical part of the arm that holds the LNBF behind the dish?
- the horizontal part of the arm that holds the LNBF in front of the dish?
- the tick mark on the bracket that holds the dish?
I'm using the tick mark (40 degree) on the bracket but when I measure the vertical part of the arm behind the dish it's about 10 degrees off (30 degrees).
|
like this:
http://www.sadoun.com/Sat/Products/F...ishes/Elev.JPG
If I understand you right, you cant measure the vertical part as the dish is "offset" by a set amount (it looks "higher" that it appears), so you must use the tick mark on the dish scale.