|
What is going on here? I setup my motor, got my south sat tuned in, tried out the motor and was getting other sats as expected.
1.turned off the ird power and ran the cable from my ird to the motor's receiver input, then I took the lnb input on the motor and connected it to the receiver port of the switch.
2.Then I took the lnb of the 30" dish and connected it to port 4
3.Connected 2 smaller dishes to ports 1 and 3 of switch
Now my signal strength is bad and the motor doesn't move. Set disecq to port 4 in ird. What did I do wrong??
|