[revx]

Originally Posted by pmb1010

The scale on the side of the motor you used would be around 57, based on the table in the sg2100 manual:

http://www.dmsiusa.com/documents/Man...100%20New1.pdf

Thank you. That is better than the 'handout' that came with it...

this is a picture of the other side of the motor; the Latitude scale, and it is indeed at about 57.

Originally Posted by lostinthewoods

Also looking at the mount of the dish on the motor, it would appear that you have not aligned the dish with properly with the necessary 0 refrence.

That was one of my concerns... where are the alighnment marks?

I'm going to read throught the manual and check things over again...
thx!
reVx