|
Hi,
I just had the same problem - not sure if it was to do with rain or not - but my motor would set the position 10degrees too far east, so a command to go to 0 would point the dish at 10e.
I'm using a ss2 and the ss2diseqc plugin. In order to force a reset, I selected "goto stored position 0" (NOT goto 0 degress, that would just point it at 10e).
When you issue that command, it drives to the extreme east, then back to 0e/0w. Once that was done, everything worked fine again!
Hope that helps someone....
Buzwad
|