Quote:
|
Originally Posted by ahoss2000
After your motor roams around on its own, what happens if you command it to go to its zero position? I have read that coax lenghts in excess of 100ft will cause the motor to malfunction. If it does go to its zero position, then set it to Diseqc1.2 and step it east or west one step. It it continues to roam, then motor is defective.
My motor is Stab HH90, and I did not have any problem what so ever with its operation. You may want to exchange it for STab motor. They are the one that created USALS standard! ( I think ) |
Well, it "wonders" on it's own when ever a command is received "green LED" shows receipt. I can send a "reference" command and it returns somewhere around "0". Lets say I tell it to goto a sat, it acts as if it does not know where anything is what so ever, it goes E<->W over and over, I have tried to manually adjust the sat, aim to G3C or I5 and then hook up receiver, after I have preselected I5/G3C and hit "SAVE" to allow it to store a point of reference for the sat, I then try to goto ANY other sat, it "wonders" and does not stop. (Tried with all 3 brands of FTA as stated above in thread)
Coax is less than 10ft. all work and troubleshooting and install being done next to the sat for fine adjustments, I am not using home/cable runs..