Quote:
|
Originally Posted by kyzursozay
Wonder if you could clarify ,the link above shows splitter's one port pass , but post above says to use splitters with dc pass on both leg's? I have 36" dish ,hh90mtr,QPH-031lnb w / 22khz 2X1 switch between motor & lnb w/single coax running from mtr. to VS Plat. DVB & 10' C/Ku Astroel RP3 feedhorn running separate C & Ku coax feed's to 922 . So I split C&Ku w/ one port pass to 922, other's to 4X1 diseqC port's 3&4. Then I ran single coax from QPH mtr to port 1 and out port to DVB. Will this work? What would be proper switch settings. Thank's  |
If I understand what you have done it will not work for long. As I am reading this your
DiSeqC switch is located between the receiver and motor? This will burn out the DiSeqC. As to dual DC Pass splitters. Should have read single pass.