Quote:
|
Originally Posted by pmb1010
bwernicke,
are you using USALS?
if so, is your long & lat set into the receiver?
I read your earlier posts, but did you do this:
1. Move motor to "reference" or center setting.
2. Line up using your compass, to magnetically adjusted position (183 degrees)
3. At that point, use USALS to drive the motor to AMC3. (did it move a lot? How much did it move?)
4. Do you have a small tv out by your dish looking for the signal on the screen?
|
1. Lat & Long entered into receiver previously and correctly. USALS is what I am using.
2. The motor was centered at 183 degrees after zeroing.
3. When selecting AMC 3, the motor moves just a little bit, which is expected? I mean, it barely moves.
4. Yes, I do have the TV and receiver out by the dish
It makes this much easier.