|
bwernicke,
are you using USALS?
if so, is your long & lat set into the receiver?
I read your earlier posts, but did you do this:
1. Move motor to "reference" or center setting.
2. Line up using your compass, to magnetically adjusted position (183 degrees)
3. At that point, use USALS to drive the motor to AMC3. (did it move a lot? How much did it move?)
4. Do you have a small tv out by your dish looking for the signal on the screen?
Last edited by pmb1010 : 07-05-2006 at 08:37 PM.
|