Quote:
|
Originally Posted by elgemcdlf
A couple of things if you have not tried them. Did you happen to set a east limit in your receiver? If so delete it. What about a complete power down of the receiver? Unplug for about 5 mins or so. Also are you attempting to use USALS? If so do you have your settings correct for your location? You are lining up at your true south sat with your motor set at 0 correct?
Steve
|
Thank you steve for your support, but I've tried :
- to set, delete, reset both EST and/or OVEST limits without success
- to unplug coax cable between receiver and motor for 1 day, but nothing
- USALS is not supported by SM2D12
- during
installation the degree for motor and dish were correctly set to my location (I was able to capture EUTELSAT W1 and HorBird signal)
-( if you mean the channel settings used by my receiver, are the same working fine with old positioning system )
- I lined up motor sat at south, then I used the satellite more near to my south position (Eutelsat W1) as REFERENCE.
The system was working fine, but suddenly the rotor turned and blocked to WEST. The strange problem is that the EST pin switch is not responding anymore. Hardware fault?