I bought VP1020 and tried it tree days already, and really frustrated, have no clue how to process to make it work anymore.
i would appreciate any help and advice on this.
here is summary about settup and equipment I use.
1. Dish and LNB: I used to use them to receive T5 with ST6000 IRD. LNB is 11.7G-12.2G, therefore, they are OK.
2. I believe the dish is pointed to T5 correctly because I used to mark the position on dish and I also use compass to adjust dish position
3. Computer is new computer HP 2.6G with new VGA card from Navidi--64M ( I am not sure if the new VGA card is necessary because my new computer HP already has build-in VGA card with 64M), anyway, I still bought it and install it on PCI slot
4. VP1020 is installed on PCI slot
5. I use download WinDTV2.2 and WinSDK2.5 from vendor's (Twinhan) website, VP1020
installation and WinDTV2.2 installation is OK
6. LOF for LNB is setup to 10750
Problem:
1. after I open WinDTV2.2, and setup LNB as above and click "apply", then choose Sat--t5 from list,
The signal strength is showing 80%, sometimes 76%, not consistent, the signal quality most of time is 0%, sometimes, it shows 2%
I click "Scan", not program locked
In addition, I tried to open program list, and click one of them (FTV), it shows" setting error, Fail to play program"
I tried many times to aligned dish, it still does not work. Is there anyting I miss there? or this Card just does not work at all.
Regards