The LO settings for universal lnbf should be:
Low LO: 9750
High LO: 10600
XpressVu uses circular feed which LO is 11250
If I were you, I would first test the card to make sure that it does work using XpressVu signal.
In your prior message, you stated that you can get a lock on ExpressVu right.
If so, connect the cable from your dish to the card, change the LO to 11250, then scan the the sat. There are few of FTA promo channel on this sat, Nimiq1.
Here is list of FTA promo channels:
12545, Right (Vertical), SR 20000
12661, right ( Vertical), SR 20000
If the card works, you should be able to watch these FTA promo channels.
Then replace the ExpressVu lnbf with the Universal one, change the LO settings as stated above. Scan the sat again, you should get channels on G11R since both G11R and Nimiq1 are at the location.
Good luck
Quote:
|
Originally Posted by mach1sc
do you know the setting for my universal FortecStar (FSKU-v) lnbf? the settings on the box seem to be the regular universal settings. i have even tryed custom settings and no luck. if you have had luck please tell your settings my dish is pointed at sat i do have sat meter to align and i did use a stand alone ird to align and verify video with my bell expressview ird. this card just will not work it may be a setting i do not know.
|