O.K., here's where the problem is. I have the Lifetime receiver signal 1st coming from a
DiSeqc switch, then lines coming into that from 2 diplexers (with dc pass on one side of them only), and then one input to a BUD and the other diplexer input to the
SG2100. The other outputs of the diplexers go to the separate inputs (C + Ku) on the Analog receiver. WHEN THE ANALOG RECEIVER IS "ON" AND I TRY TO COMMAND THE SG2100 THAT IS WHEN THE INFORMATION GETS BAD ON POSITIONING THE SG2100.
ops: It sounds like the analog receiver is causing interference with the Sg2100's commands. So.... I just make sure the analog receiver is off when positioning with the SG2100! 8) . Yes, the the diplexers are not reversed on the outputs. Unless..faulty diplexers?!?