Having trouble with install of Fortec 786NA receiver connected to
HH90 motor.
Symptom - motor is not responding / acts strange.
Previously using USALS (worked fine for months).
If I attempt to use USALS at this point, motor does not respond.
So I figured I'd "loosen" it up using DISEQC 1.2 to manually adjust.
If I say "go to zero" where should this thing go to?
- extreme left, center or extreme right?
I'm trying anything I can do with 1.2 to positon the motor. With the remote, cursor over to the "move" spot, hold down left key to move. I let go, set remote down & go over to door to look at dish. Its moving - sometimes but not always - by itself- all the way to the extreme end of range...
Suggestions?
(did unplug 110v, reseat F connectors, reset box to factory defaults)
What else?