ya.. i got BEC 6600+ .. (pretty nice machine actually) :mozilla_laughing:
Go to Main Menu... then to
Installation .. then to Transponder Setup...then go to Transponder .. when on that menu.. and go to the last one there (left or right).. when there.. the next transponder will be "New"
So enter those values there:
Frequency - 11966
Symbol Rate - 21991 (it's listed as 22000 at many places.. but i forgot .. on this machine or on other one.. - it didn't want to work with 22000.. but however worked with 21991)
Polarization - Hor (Horizontal)
Skew - leave it at 0
22 KHz - Off (more likely)
That's all - go below .and do Scan TP (can even do Scan 1 Satellite there).. but do Scan Tp maybe first..
That's all - that should work as charm.. if everything else is correct at your end.. if that does't work.. then you might have other issues.. such as Dish.. Dish size, quality of install, etc..
also.. on same screen .. on top there at the Right side..
I have those settings:
Type: Normal
LNB Type - Non-Univ.
LNB Freq 1: 5150
LNB Freq 1: 10750
I don't have any switches..
So all the rest choices below under "switch" .. i have "None" there..
Works fine for me..
Good luck..