[ctg101]

Originally Posted by pmb1010

On my home setup (80cm dish, Fortec Ultra, motor) I cannot receive G10R due to tree in the way.

I setup a 2nd system (80cm Dish, 786NA, motor) at a new location. This site has clear view to everything. Got it dialed in, 90%-95% quality on AMC5 (my southmost sat) with TV on the roof of building.

I move w/USALS to G10R and get 90% quality. Scan, find some network channels, but they are tearing/pixeling/breaking up.

Q: my Ultra does not mess up until the signal falls at or below 60% (or whatever the "red" line is on the ultra info screen, it might be 40%...).
The 786NA is breaking up at 90% signal, but only on G10R. The other Sats seemed OK and stable in the few minutes I had to set the dish up so far.

Is this particular to G10R or what???

your motor may be off a little bit, you may need to tweak it a little